DTC P061A:00 [MZI-3.7 (PCM CONNECTOR (3 TYPES))]
id0102e4477500
|
DTC P061A:00 |
Internal control module torque performance |
|---|---|
|
DETECTION CONDITION
|
• Indicates an error occurred in the PCM.
|
|
POSSIBLE CAUSE
|
• Software incompatibility issue
• PCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT PCM FOR LATEST CALIBRATION
• Program the PCM to the latest calibration.
• Turn the ignition switch off.
• Perform the KOEO self-test.
• Turn the ignition switch off.
• Perform the KOER self-test.
• Use the customer information to recreate the concern.
• Perform the self-test.
• Is the DTC P061A:00 present?
|
Yes
|
Go to the next step.
|
|
No
|
Go to Step 4.
|
||
|
3
|
INSPECT FOR CORRECT PCM OPERATION
• Disconnect all PCM connectors.
• Visually inspect for:
• Reconnect all PCM connectors and verify that they seat correctly.
• Retrieve the DTCs using the M-MDS.
• Is the same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY TROUBLESHOOTING OF DTC P061A:00 HAS BEEN COMPLETED
• Verify that all disconnected connectors reconnected.
• Clear the DTC from the PCM memory using the M-MDS.
• Perform the KOER self-test.
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
Troubleshooting completed.
|
||