NO.4 ABS OR TCS OPERATES FREQUENTLY/TCS DOES NOT WORK CORRECTLY [DSC/RSC]
id0403b3815700
4
|
ABS or TCS * operates frequently./TCS* does not work correctly.
*: DSC/RSC system function contains traction control function; DSC indicator light goes on and off while DSC/RSC is operating.
|
Possible cause
|
• There is a difference in size or air pressure between the front and rear tires
• Incorrect ABS wheel-speed signal is input to DSC/RSC HU/CM
• There is a malfunction in the engine control system (TCS malfunction)
• Tire problem (low or high air pressure, excessive wear, different grip level by four wheels)
|
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
INSPECT DTCS IN DSC/RSC HU/CM
• Inspect the DTC for the ON-BOARD DIAGNOSTIC SYSTEM.
• Have DTCs been stored in memory?
|
Yes
|
Perform the applicable DTC inspection.
(See ON-BOARD DIAGNOSIS [DSC/RSC].)
|
No
|
Go to the next step.
|
||
2
|
INSPECT TIRE SIZE AND AIR PRESSURE
• Inspect the tire size and the air pressure.
• Are size and air pressure as specified?
|
Yes
|
Go to the next step.
|
No
|
Replace with specified tires and adjust tire air pressure.
|
||
3
|
INSPECT ABS WHEEL-SPEED SENSOR OUTPUT VALUE
• Inspect the output value from the ABS wheel-speed sensor.
• Is the output value normal?
|
Yes
|
Go to the next step.
|
No
|
• ABS wheel-speed sensor installation inspection:
Inspect the sensor for looseness and verify that it is securely installed.
• Sensor rotor installation inspection:
Inspect the sensor rotor for poor installation and chipping of sensor rotor teeth. (If sensor rotor is installed poorly, it may cause output of abnormal wave form at high speed.)
|
||
4
|
VERIFY THAT TIRE CONDITION
• Verify tire condition for following:
• Are tires condition okay?
|
Yes
|
Find malfunctioning part according to “INTERMITTENT CONCERN TROUBLESHOOTING”.
|
No
|
Adjust, repair or replace tire.
|