DTC P2806:00 [AY6A-EL, AY6AX-EL]
id0502k1578500
|
DTC P2806:00 |
Neutral position learning (Not performed yet) |
|---|---|
|
DETECTION CONDITION
|
• Conditions: Diagnosis tester request “N position adaptation”
• Circumstances: “N position adaptation” not performed
• Time period: Determined after 1 time
Diagnostic support note:
• The MIL does not illuminate.
• The AT warning light illuminates.
• PENDING CODE is not available.
• FREEZE FRAME DATA is available.
• The DTC is stored in the TCM memory.
|
|
FAIL-SAFE FUNCTION
|
• Locks start lock signal
|
|
POSSIBLE CAUSE
|
• Not set “N” position when writing condition
• Selector cable mis-adjustment
|
|
SYSTEM WIRING DIAGRAM
|
—
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded on the repair order?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
INSPECT TR SWITCH
• Inspect the TR switch.
• Is there any malfunction?
|
Yes
|
Adjust or replace the TR switch or selector cable, then go to the next step.
(See SELECTOR CABLE ADJUSTMENT.)
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Make sure to reconnect all the disconnected connectors.
• Clear the DTC using the M-MDS.
• Switch the ignition OFF (LOCK), then switch it ON.
• Verify the DTCs recorded in the TCM.
• Is the same DTC present?
|
Yes
|
Repeat Step 3.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY NO DTCs ARE PRESENT
• Perform the “Reading DTCs Procedure”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||