DTC P0883:00 [AY6A-EL, AY6AX-EL]


id0502k1820100

DTC P0883:00

TCM B+ high

DETECTION CONDITION
•  Conditions: Engine idling and TCM communication normal
•  Circumstances: Ignition terminal voltage 18V or more detected
•  Time period: Determined after 5 times lasting 1 or more seconds
Diagnostic support note:
•  The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle.
•  The AT warning light illuminates.
•  PENDING CODE is not available.
•  FREEZE FRAME DATA is available.
•  The DTC is stored in the TCM memory.
FAIL-SAFE FUNCTION
•  Emergency mode 3
POSSIBLE CAUSE
•  Generator malfunction
•  TCM malfunction
SYSTEM WIRING DIAGRAM

Diagnostic procedure

STEP

INSPECTION

ACTION

1
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
•  Has the FREEZE FRAME DATA been recorded on the repair order?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
•  Verify related Service Information availability.
•  Is any related repair information available?
Yes
Perform repair or diagnosis according to the available repair information.
•  If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
VERIFY DTC IS PRESENT
•  Switch the ignition OFF (LOCK), then switch it ON (Engine off).
•  Read the DTC in the PCM.
•  Are the following DTCs output?
―  P0620:00 (Generator control circuit)
―  P0625:00 (Generator field terminal circuit low)
―  P0626:00 (Generator field terminal circuit high)
Yes
Go to the applicable DTC inspection.
.)
No
Go to the next step.
4
VERIFY DTC TROUBLESHOOTING COMPLETED
•  Make sure to reconnect all the disconnected connectors.
•  Clear the DTC using the M-MDS.
•  Perform the following procedure to ensure that the DTC has been resolved:
1.  Start the engine.
2.  Warm up the engine and transaxle.
3.  Drive the vehicle in D position and make sure that the gears shift smoothly from 1GR to 6GR.
•  Is the same DTC present?
Yes
Replace the TCM, then go to the next step.
No
Go to the next step.
5
VERIFY NO DTCs ARE PRESENT
•  Perform the “Reading DTCs Procedure”.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
No
DTC troubleshooting completed.