DTC U2197 [INSTRUMENT CLUSTER]

id0902e8859500

DESCRIPTION

Erratic signal from PCM
DETECTION CONDITION
•  Instrument cluster detects invalid vehicle speed from PCM under the following conditions:
―  Passed 20 s after switch the ignition to ON
―  Odometer is normal and more than 30 km {19 mile}
―  Battery voltage is more than 10 V
―  Received invalid data from PCM for 1 s
POSSIBLE CAUSE
•  PCM malfunction
•  Instrument cluster malfunction

Diagnostic Procedure

Step

Inspection

Action
1
PERFORM PCM DTC INSPECTION
•  Perform the PCM DTC inspection using the M-MDS.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [MZI-3.7 (PCM CONNECTOR (2 TYPES))].)
(See DTC TABLE [MZI-3.7 (PCM CONNECTOR (3 TYPES))].)
No
Go to the next step.
2
PERFORM INSTRUMENT CLUSTER DTC INSPECTION
•  Clear the DTC from the instrument cluster memory using the M-MDS.
•  Switch the ignition to ON and wait for 20 s.
•  Perform the instrument cluster DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [MZI-3.7].)
No
Go to the next step.
3
VERIFY TROUBLESHOOTING COMPLETED
•  Clear the DTC from the instrument cluster memory using the M-MDS.
•  Switch the ignition to ON and wait for 20 s.
•  Perform the instrument cluster DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the instrument cluster, then go to the next step.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
No
Go to the next step.
4
VERIFY THAT NO OTHER DTCs ARE RECORDED
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [INSTRUMENT CLUSTER].)
No
DTC troubleshooting completed.