WHEEL HUB COMPONENT REMOVAL/INSTALLATION


id031200800400

Caution
•  Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (body side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.

1.  Remove the rear ABS wheel-speed sensor. (See REAR ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION.)

2.  Remove the rear lateral link. (See REAR LATERAL LINK REMOVAL/INSTALLATION.)

3.  Remove the rear coil spring. (See REAR COIL SPRING REMOVAL/INSTALLATION.)

4.  Remove the rear lower arm. (See REAR LOWER ARM REMOVAL/INSTALLATION.)

5.  Remove in the order indicated in the table.

6.  Install in the reverse order of removal.

7.  Inspect for rear wheel alignment, and adjust it as necessary. (See REAR WHEEL ALIGNMENT.)

ac9wzw00000054

1
Rear parking brake cable
2
Locknut
3
Caliper component
4
Rear trailing link and rear wheel hub component
5
Disc plate
6
Wheel hub component
7
Parking brake shoe component
8
Wheel hub bolt


Locknut Removal Note

1.  Lock the hub by applying the brakes.

2.  Knock the crimped portion of the locknut outward using a small chisel and a hammer.

ac9wzw00000055

3.  Remove the locknut.


Brake Caliper Component Removal Note

1.  Remove the brake caliper component from the trailing link and suspend it out of the way using a cable.

ac9uuw00001239


Rear Trailing Link and Rear Wheel Hub Component Removal Note

1.  Support the rear trailing link and rear wheel hub component using a jack.

ac9uuw00001244

Caution
•  Removing the rear trailing link and rear wheel hub component is dangerous. The rear trailing link and rear wheel hub component could fall and cause serious injury or death. Verify that the jack securely supports the trailing link.

2.  Separate the rear drive shaft (rear axle side) from the wheel hub.

3.  Remove the trailing link and rear wheel hub component.


Wheel Hub Bolt Removal Note

Note
•  The wheel hub bolts do not need to be removed unless they are being replaced.

1.  Remove the wheel hub bolt using a press.

ac9uuw00001240


Wheel Hub Bolt Installation Note

1.  Install the new wheel hub bolt using a press.

ac9uuw00001241


Locknut Installation Note

1.  Install a new locknut and stake it as shown.

ac9uuw00001245