INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [AW6AX-EL]

id0517j6801300

Warning

•  A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until then are cool before replacing the ATF.

1.  Disconnect the negative battery cable.

2.  Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-3.7].)

3.  Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [AW6AX-EL].)

4.  Remove the oil cooler.

ac9uuw00001958

5.  Remove the oil pipe. (See OIL COOLER REMOVAL/INSTALLATION [AW6AX-EL].)

6.  Remove the control valve body. (See CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6AX-EL].)

Caution

•  Do not damage the input/turbine speed sensor.

7.  Remove the input/turbine speed sensor.

ac9uuw00001959

8.  Install the input/turbine speed sensor.

9.  Install the control valve body. (See CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6AX-EL].)

10.  Install the oil pipe. (See OIL COOLER REMOVAL/INSTALLATION [AW6AX-EL].)

11.  Install the oil cooler. (See OIL COOLER REMOVAL/INSTALLATION [AW6AX-EL].)

12.  Add ATF to the specified level. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [AW6AX-EL].)

13.  Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-3.7].)

14.  Connect the negative battery cable.

15.  Perform the mechanical system test. (See MECHANICAL SYSTEM TEST [AW6AX-EL].)