FUEL INJECTOR REMOVAL/INSTALLATION [MZI-3.7]

id0114d2800600

Warning

•  Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring to the “BEFORE SERVICE PRECAUTION”.

1.  Complete the “BEFORE SERVICE PRECAUTION”. (See BEFORE SERVICE PRECAUTION [MZI-3.7].)

2.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7].)

3.  Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [MZI-3.7].)

4.  Remove the dynamic chamber (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-3.7].)

5.  Remove in the order indicated in the table.

6.  Install in the reverse order of removal.

7.  Complete the “AFTER SERVICE PRECAUTION”. (See AFTER SERVICE PRECAUTION [MZI-3.7].)

ac9wzw00000889

1	Quick release connector (See QUICK RELEASE CONNECTOR REMOVAL/INSTALLATION [MZI-3.7].)
2	Wiring harness retainer
3	Fuel injector connectors
4	Fuel distributor
5	Clip
6	Fuel injector (See Fuel Injector Removal Note.) (See Fuel Injector Installation Note.)
7	O-ring

Fuel Injector Removal Note

Caution

•  Use of a deformed injector retaining clip will cause the injector to not engage correctly. Always use a new clip when reattaching the injector, otherwise it may cause the injector to rotate.

1.  Insert a screwdriver between the injector cup and the clip fingers.

ac9wzw00002162

Note

•  When rotating the screwdriver to spread the clip fingers, deform them sufficiently to make sure they release from the notched edge of the injector cup.

ac9wzw00002163

2.  Rotate the screwdriver to spread the clip fingers and remove them from the injector cup.

3.  Pull the injector and clip out of the rail.

4.  Remove the clip from the injector according to the following:

(1)  Grasp the clip with a pair of pliers.

(2)  Pull the clip parallel to the injector groove, and remove it from the injector.

ac9wzw00002164

(3)  Discard the clip.

Fuel Injector Installation Note

1.  Install the new O-ring.

2.  Lightly lubricate the injector groove and O-ring.

3.  Pre-attach a new clip in the injector groove.

Note

•  When the clip is attached correctly, the central area of the injector and the clip finger positions are aligned.

4.  Hold the injector firmly, push the clip into the injector until the clip stops sliding.

ac9wzw00002165

5.  Verify that the injector connector position is correct, and press the injector and clip into the injector cup. Continue pressing until the clip contacts the lower surface of the injector cup.

6.  Verify that the injector and clip are correctly attached with the clip locked onto the injector cup notch.