DTC B1506 [BCM]
id0902f5831600
|
Description |
Turn switch (RH) circuit malfunction |
|---|---|
|
Detection condition
|
• Short to ground in turn switch (RH) circuit with the turn switch off.
|
|
Possible cause
|
• Light switch connector or terminal malfunction
• Turn switch malfunction
• BCM connector or terminal malfunction
• Short to ground in wiring harness between the following terminals:
• BCM malfunction
|
 |
|
Diagnostic procedure
|
Step |
Inspection |
Action |
|
|---|---|---|---|
|
1
|
INSPECT LIGHT SWITCH CONNECTOR
• Turn the ignition switch to the OFF position.
• Disconnect the negative battery cable.
• Disconnect the light switch connector.
• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
• Is there any malfunction?
|
Yes
|
Repair or replace the connector, then go to Step 5.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT TURN SWITCH
• Inspect the turn switch.
(See LIGHT SWITCH INSPECTION.)
• Is there any malfunction?
|
Yes
|
Replace the light switch, then go to Step 5.
|
|
No
|
Go to the next step.
|
||
|
3
|
INSPECT BCM CONNECTOR
• Disconnect the BCM connector.
• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
• Is there any malfunction?
|
Yes
|
Repair or replace the connector, then go to Step 5.
|
|
No
|
Go to the next step.
|
||
|
4
|
INSPECT FOR SHORT TO GROUND IN TURN SWITCH (RH) CIRCUIT
• Verify that the light switch and BCM connectors are disconnected.
• Inspect for continuity between following terminal (wiring harness-side) and body ground:
• Is there continuity?
|
Yes
|
Repair or replace the wiring harness which has a short to ground, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Make sure to reconnect all disconnected connectors.
• Reconnect the negative battery cable.
• Clear the DTC for the BCM using the M-MDS.
(See CLEARING DTC [BCM].)
• Retrieve the BCM DTCs using the M-MDS.
(See DTC INSPECTION [BCM].)
• Is the same DTC displayed?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the BCM.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
6
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [BCM].)
|
|
No
|
DTC troubleshooting completed.
|
||