ELECTRIC PARKING BRAKE SWITCH REMOVAL/INSTALLATION

id041200700400

Caution

•   If the electric parking brake switch is not operated after replacing it, the electric parking brake will not operate/release normally. If the electric parking brake switch is replaced, operate the electric parking brake switch.

1.  Remove the select lever knob. (See SELECTOR LEVER REMOVAL/INSTALLATION [A71M].)

2.  Disconnect the negative lead-acid battery terminal. (See NEGATIVE LEAD-ACID BATTERY TERMINAL DISCONNECTION/CONNECTION.)

3.  Remove the shift panel. (See SHIFT PANEL REMOVAL/INSTALLATION.)

4.  Remove the screws.

a30zzw00004308

5.  Remove the electric parking brake switch.

6.  Install in the reverse order of removal.

7.  After installation, perform the following procedure.

(1)  Pull up the electric parking brake switch.

(2)  Press the electric parking brake switch.

(3)  Operate the electric parking brake switch again and verify that the electric parking brake operates/releases.

•  If the electric parking brake cannot be operated/released, perform a DTC inspection as a malfunction of the electric parking brake may have occurred. (See DTC INSPECTION.)