DTC U2300:56 [APPROACHING VEHICLE AUDIBLE SYSTEM DEVICE]


id0902y0138500


Outline

System malfunction location

Configuration data unmatched with body control module (BCM)

Detection condition
•  Configuration data of the approaching vehicle audible system device and body control module (BCM) are not matched.
Fail-safe
•  Approaching vehicle alert sound is generated at maximum volume
Possible cause
Note
•  To correctly write the configuration data sent from the body control module (BCM) to the approaching vehicle audible system device, 30 s or more have to be elapsed since the main power is switched ON (READY off or on).
•  DTCs are stored in the body control module (BCM).
―  Body control module (BCM) configuration not implemented
―  Body control module (BCM) internal memory malfunction
•  Body control module (BCM) configuration data error
•  Approaching vehicle audible system device malfunction
System wiring diagram
Not applicable
Connector diagram
Not applicable


Diagnostic Procedure

Step

Inspection

Results

Action

1
VERIFY BODY CONTROL MODULE (BCM) DTCs
•  Perform the DTC inspection for the body control module (BCM).
•  Is a DTC displayed?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
No
Go to the next step.
2
RESET CONFIGURATION DATA FOR BODY CONTROL MODULE (BCM)
•  Using the M-MDS, perform the body control module (BCM) configuration.
•  Clear the DTC recorded in the memory.
•  Switch the main power ON (READY off or on) and wait for 30 s or more.
•  Perform the DTC inspection for the approaching vehicle audible system device.
•  Is the same Pending DTC present?
Yes
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, replace the approaching vehicle audible system device and perform the repair completion verification.
No
Go to the next step.
Repair completion verification
VERIFY IF OTHER DTC IS DISPLAYED
•  Perform the DTC inspection.
•  Are any other DTCs displayed?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
No
DTC troubleshooting completed.