DETERMINING SHORT TO POWER SUPPLY LOCATION (CAN-BUS No.8) [R.H.D.]

id100226004700

Caution

•  Perform the following malfunction diagnosis only when it is diagnosed with a short to power supply by CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [R.H.D.].)

System Wiring Diagram

a30zzw00006616

Determination Procedure

Caution

•  When disconnecting the connector, verify that there is no looseness, damage, deformation, corrosion, or poor connection of the connector terminals.

•  When inspecting the connector, touch it with a paper clip or similar thin pin without directly inserting a tester probe into the terminal.

•  Disconnect the negative lead-acid battery terminal before performing any work that requires handling of connectors.

Step	Inspection		Action
1	INSPECT CAN LINE BETWEEN CONNECTOR C-19 AND BODY CONTROL MODULE (BCM) FOR SHORT TO POWER SUPPLY •  Switch the main power OFF. •  Disconnect the negative lead-acid battery terminal. (See NEGATIVE LEAD-ACID BATTERY TERMINAL DISCONNECTION/CONNECTION.) •  Disconnect the connector C-19. •  Connect the negative lead-acid battery terminal. (See NEGATIVE LEAD-ACID BATTERY TERMINAL DISCONNECTION/CONNECTION.) •  Switch the main power ON (READY off). •  Measure the voltage at body control module (BCM) terminals 3V and 3U. •  Is the voltage between 1.5—3.5 V?	Yes	Go to Step 3.
		No	Go to the next step.
2	INSPECT BODY CONTROL MODULE (BCM) FOR SHORT TO POWER SUPPLY •  Switch the main power OFF. •  Disconnect the negative lead-acid battery terminal. (See NEGATIVE LEAD-ACID BATTERY TERMINAL DISCONNECTION/CONNECTION.) •  Disconnect the connector 3 which has body control module (BCM) terminals 3V and 3U. •  Connect the connector C-19. •  Connect the negative lead-acid battery terminal. (See NEGATIVE LEAD-ACID BATTERY TERMINAL DISCONNECTION/CONNECTION.) •  Switch the main power ON (READY off). •  Measure the voltage at body control module (BCM) terminals 3V and 3U (wiring harness side). •  Is the voltage between 1.5—3.5 V?	Yes	Replace the body control module (BCM) because there is a short to the power supply in the body control module (BCM). (See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION.)
		No	Repair or replace the wiring harness between the body control module (BCM) and connector C-19 because the wiring harness is shorted to the power supply.
3	INSPECT EMERGENCY CALL UNIT FOR SHORT TO POWER SUPPLY •  Switch the main power OFF. •  Disconnect the negative lead-acid battery terminal. (See NEGATIVE LEAD-ACID BATTERY TERMINAL DISCONNECTION/CONNECTION.) •  Disconnect the emergency call unit connector. •  Connect the connector 3 which has body control module (BCM) terminals 3V and 3U. •  Connect the negative lead-acid battery terminal. (See NEGATIVE LEAD-ACID BATTERY TERMINAL DISCONNECTION/CONNECTION.) •  Switch the main power ON (READY off). •  Measure the voltage at body control module (BCM) terminals 3V and 3U. •  Is the voltage between 1.5—3.5 V?	Yes	Replace the emergency call unit because there is a short to the power supply in the emergency call unit. (See EMERGENCY CALL UNIT REMOVAL/INSTALLATION [(E)].)
		No	Repair or replace the wiring harness between the emergency call unit and connector C-19 because the wiring harness is shorted to the power supply.