DTC P2762 [SJ6A-EL]


DTC P2762	TCC control solenoid range/performance (stuck)
DETECTION CONDITION	• Feedback current corresponding to solenoid current command value is irregular when engine is running. Diagnostic support note: • The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle. • A PENDING CODE is not available. • FREEZE FRAME DATA is available. • The AT warning light illuminates. • The DTC is stored in the TCM memory.
POSSIBLE CAUSE	• ATF level low • Deteriorated ATF • TCC control solenoid stuck • Control valve stuck • TCM malfunction


STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED • Has the FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY • Verify related Service Bulletins and/or on-line repair information availability. • Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT ATF CONDITION • Turn the ignition switch to the LOCK position. • Inspect the ATF condition. - Clear red: Normal - Light red (pink): Water mixed in fluid - Reddish brown: Deteriorated ATF • Is it normal? (See Automatic Transmission Fluid (ATF) Condition Inspection.)	Yes	Go to the next step.
3		No	If the ATF color is light red or reddish brown, replace ATF, then go to Step 6. (See AUTOMATIC TRANSMISSION FLUID (ATF) REPLACEMENT [SJ6A-EL].)
4	INSPECT ATF LEVEL • Start the engine. • Warm up the AT. • Is the ATF level within the specification? (See AUTOMATIC TRANSMISSION FLUID (ATF) LEVEL ADJUSTMENT [SJ6A-EL].)	Yes	Go to the next step.
4		No	Add ATF to the specified level, then go to Step 6. (See AUTOMATIC TRANSMISSION FLUID (ATF) LEVEL ADJUSTMENT [SJ6A-EL].)
5	INSPECT LINE PRESSURE • Start the engine. • Measure the line pressure. (See Line Pressure Test.) • Are the line pressures within the specifications?	Yes	Go to the next step.
5		No	• All ranges: Replace the oil pump or control valve body, then go to the next step. • Any ranges: Replace the AT, then go the next step. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [SJ6A-EL].)
6	VERIFY TROUBLESHOOTING OF DTC P2762 COMPLETED • Make sure to reconnect all the disconnected connectors. • Clear the DTC from the memory using the M-MDS. • Drive the vehicle in D range and make sure that gears shift smoothly from 1GR to 6GR (TCC operation). • Is same DTC present?	Yes	Replace the TCM, then go to the next step. (See TCM REMOVAL/INSTALLATION [SJ6A-EL].)
6		No	Go to the next step.
7	VERIFY AFTER REPAIR PROCEDURE • Perform the "After Repair Procedure". (See AFTER REPAIR PROCEDURE [SJ6A-EL].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [SJ6A-EL].)
7		No	Troubleshooting completed.