GPS ANTENNA FEEDER REMOVAL/INSTALLATION

id092000812100

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Scuff plate (passenger's side) (See SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Front side trim (passenger's side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  A-pillar trim (passenger's side) (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(4)  Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)

(5)  Center panel No.2 (See CENTER PANEL No.2 REMOVAL/INSTALLATION.)

(6)  Meter hood (See METER HOOD REMOVAL/INSTALLATION.)

(7)  Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

(8)  Center display component (See CENTER DISPLAY REMOVAL/INSTALLATION.)

3.  Disconnect the connector.

amxzzw00004598

4.  Remove the wiring harness clips in the position shown in the figure.

5.  Remove the GPS antenna feeder.

6.  Install in the reverse order of removal.