ANTENNA FEEDER NO.1 REMOVAL/INSTALLATION

id092000812200

L.H.D.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Scuff plate (passenger's side) (See SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Front side trim (passenger's side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  A-pillar trim (passenger's side) (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(4)  Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)

(5)  Center panel No.2 (See CENTER PANEL No.2 REMOVAL/INSTALLATION.)

(6)  Meter hood (See METER HOOD REMOVAL/INSTALLATION.)

3.  Remove the duct and side duct.

amxuuw00002899

4.  Disconnect the connector.

amxzzw00004599

5.  Remove the wiring harness clips in the position shown in the figure.

6.  Remove antenna feeder No.1.

7.  Install in the reverse order of removal.

R.H.D.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Scuff plate (See SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(4)  Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)

(5)  Center panel No.2 (See CENTER PANEL No.2 REMOVAL/INSTALLATION.)

(6)  Upper column cover (See COLUMN COVER REMOVAL/INSTALLATION.)

(7)  Lower column cover (See COLUMN COVER REMOVAL/INSTALLATION.)

(8)  Meter hood (See METER HOOD REMOVAL/INSTALLATION.)

(9)  Audio unit (See AUDIO UNIT REMOVAL/INSTALLATION.)

(10)  Selector lever knob (AT) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.)

(11)  Shift lever knob (MT)

(12)  Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION.)

(13)  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

(14)  Parking brake lever boot panel (See PARKING BRAKE LEVER BOOT PANEL REMOVAL/INSTALLATION.)

(15)  Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)

(16)  Front console panel (See FRONT CONSOLE PANEL REMOVAL/INSTALLATION.)

(17)  Front console component (See FRONT CONSOLE REMOVAL/INSTALLATION.)

(18)  Bonnet release lever (See BONNET RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION.)

(19)  Driver-side lower panel (See DRIVER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)

3.  Remove the duct and side duct.

amxzzw00003622

4.  Disconnect the connector.

amxzzw00004600

5.  Remove the wiring harness clips in the position shown in the figure.

6.  Remove antenna feeder No.1.

7.  Install in the reverse order of removal.