NO.24 ENGINE STALLS WHEN SHIFTED TO D RANGE, OR IN R POSITION [SJ6A-EL]

id050307802900

24

Engine stalls when shifted to D range, or in R position

DESCRIPTION

•  Engine stalls when shifting from N or P position to D range or R position at idle.

POSSIBLE CAUSE

•  The malfunction is on the engine control side (e.g. electronic controlled throttle system). Otherwise, the malfunction is in the turbine sensor (engine sometimes starts) or the TCC circuit (engine always stalls).

Note

•  Before following the troubleshooting steps, make sure that the Automatic Transmission On-Board Diagnostic and Automatic Transmission Basic Inspection are conducted. (See BASIC INSPECTION [SJ6A-EL].)

Diagnostic procedure

STEP	INSPECTION		ACTION
1	• Perform the symptom troubleshooting “NO.5 ENGINE STALLS-AFTER START/AT IDLE”. (See NO.5 ENGINE STALLS-AFTER START/AT IDLE [L8, LF].) • Is the engine control system normal?	Yes	Go to the next step.
1		No	Repair or replace the malfunctioning part according to the inspection results.
2	• Remove the torque converter. (See TORQUE CONVERTER REMOVAL/INSTALLATION [SJ6A-EL].) • Inspect the torque converter. • Is the torque converter normal?	Yes	Inspect for bending, damage, corrosion or kinks of the oil cooler pipes. • If normal, replace the control valve body. (See CONTROL VALVE BODY REMOVAL [SJ6A-EL].) (See CONTROL VALVE BODY INSTALLATION [SJ6A-EL].) • If problem remains, overhaul the transmission and repair or replace any malfunctioning parts. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [SJ6A-EL].) (See Automatic Transmission Workshop Manual [SJ6A-EL].)
2		No	Replace the torque converter. (See TORQUE CONVERTER REMOVAL/INSTALLATION [SJ6A-EL].)
3	• Verify test results. ― If normal, return to the diagnostic index to service any additional symptoms. ― If malfunction remains, inspect the related Service Information and perform repair or diagnosis. • If the vehicle is repaired, troubleshooting completed. • If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM. (See TCM REMOVAL/INSTALLATION [SJ6A-EL].)

24	Engine stalls when shifted to D range, or in R position
DESCRIPTION	• Engine stalls when shifting from N or P position to D range or R position at idle.
POSSIBLE CAUSE	• The malfunction is on the engine control side (e.g. electronic controlled throttle system). Otherwise, the malfunction is in the turbine sensor (engine sometimes starts) or the TCC circuit (engine always stalls). Note • Before following the troubleshooting steps, make sure that the Automatic Transmission On-Board Diagnostic and Automatic Transmission Basic Inspection are conducted. (See BASIC INSPECTION [SJ6A-EL].)