HAZARD WARNING SWITCH REMOVAL/INSTALLATION

id091800803000

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [F35M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [B65M-R].)

(2)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(3)  Front console component (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION.)

(4)  Glove compartment (Vehicles with center panel unit) (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(5)  Center panel unit (Vehicles with center panel unit) (See CENTER PANEL UNIT REMOVAL/INSTALLATION.)

(6)  Center panel (Vehicles without center panel unit) (See CENTER PANEL REMOVAL/INSTALLATION.)

3.  Remove the hazard warning switch in the direction of the arrow (2) shown in the figure while pressing the hazard warning switch tabs in the direction of the arrow (1).

am2zzw00002497

4.  Install in the reverse order of removal.