CLUTCH STROKE SENSOR INSPECTION [SKYACTIV-G 1.3, SKYACTIV-G 1.5]

id0140q1889000

Note

•  The clutch stroke sensor cannot be removed as a single unit. When replacing the clutch stroke sensor, replace it together with the clutch master cylinder as a single unit.

PID/DATA Monitor Inspection

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Verify that the clutch pedal position (PID: CPP) input from the clutch stroke sensor is within the standard when the clutch pedal is depressed. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 1.3, SKYACTIV-G 1.5)].) (See PCM INSPECTION [SKYACTIV-G 1.3, SKYACTIV-G 1.5].)

•  If not within the specification, replace the clutch master cylinder. (See CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION [F65M-R].) (See CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION [F66M-R].)