UP SWITCH INSPECTION [EW6A-EL]

id0517l2600500

Continuity Inspection

Note

•  The up switch is built into the selector lever component.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Selector lever knob (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

(2)  Center console tray (See CENTER CONSOLE TRAY REMOVAL/INSTALLATION.)

(3)  Shift bezel (See SHIFT BEZEL REMOVAL/INSTALLATION.)

(4)  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

(5)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

(6)  Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION.)

(7)  Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)

(8)  CD player (with CD player) (See CD PLAYER REMOVAL.) (See CD PLAYER INSTALLATION.)

(9)  DVD/CD player (with DVD/CD player) (See DVD/CD PLAYER REMOVAL.) (See DVD/CD PLAYER INSTALLATION.)

(10)  Front console (See FRONT CONSOLE REMOVAL/INSTALLATION.)

(11)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(12)  Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)

3.  Disconnect the selector lever component connector.

am2zzw00007741

4.  Verify that the continuity between selector lever component terminals C and H.

adejjw00010856

•  If not as verified, replace the selector lever component. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)