THEFT-DETERRENT HORN INSPECTION

id091400004900

5HB

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Rear package tray (See REAR PACKAGE TRAY REMOVAL/INSTALLATION.)

(2)  Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION.)

(3)  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)

(4)  Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

3.  Partially peel back the trunk side trim (LH) to the position allowing removal of the theft-deterrent horn. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

4.  Remove the theft-deterrent horn. (See THEFT-DETERRENT HORN REMOVAL/INSTALLATION.)

5.  Apply battery positive voltage to horn terminal A, and connect the horn retaining bolt to ground as shown in the figure, and then verify that the horn sounds.

am2zzw00008318

•  If the horn does not sound, replace the horn. (See THEFT-DETERRENT HORN REMOVAL/INSTALLATION.)

4SD

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION.)

(2)  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)

(3)  Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

3.  Partially peel back the trunk side trim (RH) to the position allowing removal of the theft-deterrent horn. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

4.  Remove the theft-deterrent horn. (See THEFT-DETERRENT HORN REMOVAL/INSTALLATION.)

5.  Apply battery positive voltage to horn terminal A, and connect the horn retaining bolt to ground as shown in the figure, and then verify that the horn sounds.

am2zzw00008317

•  If the horn does not sound, replace the horn. (See THEFT-DETERRENT HORN REMOVAL/INSTALLATION.)