OIL SEAL REPLACEMENT

id051700804400

1.  Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT.)

Caution

•  The oil seal is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines contact the oil seal.

2.  Remove the drive shaft and/or joint shaft. (See DRIVE SHAFT REMOVAL/INSTALLATION [ZJ, ZY].)(See JOINT SHAFT REMOVAL/INSTALLATION [ZJ, ZY].)

3.  Remove the oil seal using the screwdriver.

4.  Using the SST and a hammer, tap a new oil seal in evenly until the SST contacts the transaxle case.

am2zzw00000818

5.  Install the drive shaft and/or joint shaft. (See DRIVE SHAFT REMOVAL/INSTALLATION [ZJ, ZY].)(See JOINT SHAFT REMOVAL/INSTALLATION [ZJ, ZY].)

6.  Add ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT.)

7.  Perform the mechanical system test. (See MECHANICAL SYSTEM TEST.)