HOLD SWITCH INSPECTION

id051700809000

1. Disconnect the selector lever component connector.

(1) Disconnect the negative battery cable.

(2) Remove the side wall. (See SIDE WALL REMOVAL/INSTALLATION.)

(3) Remove the front console component. (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION.)

(4) Disconnect the selector lever component connector.

L.H.D.

am2zzw00001181

R.H.D.

am2zzw00001013

2. Verify continuity as indicated in the table.

Type A

am2zzw00003644

Type B

am2zzw00003645

• If there is any malfunction, replace the selector lever. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

HOLD switch specification

Test Condition	Type A	Type B
HOLD switch is released	There is no continuity between terminals C and D.	There is no continuity between terminals A and B.
HOLD switch is depressed	There is continuity between terminals C and D.	There is continuity between terminals A and B.