DTC U0415:92 [INSTRUMENT CLUSTER]

id0902e8988400

Note
•  If the ignition switch is turned off after reprogramming the PCM and then turned to the ON position within 30 s, the PCM reprogramming cannot be completed correctly and DTC 0415:92 is stored.

DTC U0415:92

On request from ABS HU/CM OR DSC HU/CM
Detection Condition
On request malfunction from ABS HU/CM or DSC HU/CM
Possible Causes
•  ABS HU/CM or DSC HU/CM malfunction
•  The ignition switch is turned to the ON position within 30 s after the PCM reprogramming

Diagnostic Procedure

Step

Inspection

Action
1
INSPECT ABS HU/CM FOR MALFUNCTION
•  Turn the ignition switch to the LOCK position.
•  Connect the M-MDS to the DLC-2.
•  Perform the ABS HU/CM or DSC HU/CM DTC inspection using the M-MDS.
•  Is the DTC displayed again?
Yes
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSIS [ABS].)
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].)
No
Go to the next step.
2
VERIFY THAT NO OTHER DTCs ARE RECORDED
•  Clear DTCs using the M-MDS.
•  Perform the instrument cluster DTC inspection using the M-MDS.
•  Is DTC U0415:92 displayed?
Yes
Replace the ABS HU/CM or DSC HU/CM.
(See ABS HU/CM REMOVAL/INSTALLATION [L.H.D.].)
(See ABS HU/CM REMOVAL/INSTALLATION [R.H.D.].)
(See DSC HU/CM REMOVAL/INSTALLATION [L.H.D.].)
(See DSC HU/CM REMOVAL/INSTALLATION [R.H.D.].)
No
DTC troubleshooting completed.