HEADLIGHT LEVELING SWITCH INSPECTION

id091800464300

1.  Remove the following parts:

(1)  Front scuff plate (driver-side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Front side trim (driver-side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [F35M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [B65M-R].)

(4)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(5)  Front console component (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION.)

(6)  Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

(7)  Lower panel (driver-side) (See LOWER PANEL REMOVAL/INSTALLATION.)

(8)  Headlight leveling switch (See HEADLIGHT LEVELING SWITCH REMOVAL/INSTALLATION.)

2.  Verify that the resistance and continuity between the headlight leveling switch terminals is as indicated in the table using a tester.

am2zzw00003489

•  If not as indicated in the table, or if the resistance is not within the specification, replace the headlight leveling switch.

am2zzw00002280