NO.20 NOISE OCCURS AT IDLE WHEN VEHICLE IS STOPPED IN ALL POSITIONS/RANGES [FN4A-EL]


id0503a1802500

20

Noise occurs at idle when vehicle is stopped in all positions/ranges

DESCRIPTION

• Transaxle noisy in all positions and ranges when vehicle is idling.

POSSIBLE CAUSE

• The malfunction is in the oil pump which causes a high-pitched noise to be emitted from the transaxle at idle.
Note
• If a noise is emitted during shifting only, the malfunction is in shift solenoid D, E or shift solenoid A, B, C. If a noise is emitted during shifting at certain gears only or during deceleration only, it is gear noise.
• Before following troubleshooting steps, make sure that Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.

Diagnostic procedure

STEP

INSPECTION

ACTION

1
• Inspect engine condition.
• Is any engine concern (i. e. rough idle)?
Yes
Go to appropriate symptom troubleshooting.
No
Go to next step.
2
• Does noise stop when solenoid connector is disconnected?
Yes
Go to next step.
No
Overhaul control valve body and repair or replace any defective parts.
(See ATX workshop manual (FN4A-EL) [1623-10-98E].)
If problem remains, overhaul transaxle and repair or replace any defective parts.
(See ATX workshop manual (FN4A-EL) [1623-10-98E].)
3
• Check the value at the following PIDs using the WDS or equivalent.
- TP
- VSS
- TSS
• Are PID values normal?
Yes
Go to next step.
No
Repair or replace any defective parts.
4
• Disconnect PCM.
• Is resistance between ground terminal at PCM connector and body ground less than 5.0 ohms?
Yes
Go to next step.
No
Repair open ground circuit. Reconnect PCM.
5
• Check LPS PID value.
• Is LPS PID value normal?
Yes
Overhaul control valve body and repair or replace any defective parts.
(See ATX workshop manual (FN4A-EL) [1623-10-98E].)
If problem remains, overhaul transaxle and repair or replace any defective parts.
(See ATX workshop manual (FN4A-EL) [1623-10-98E].)
No
Repair or replace any defective parts.
6
• Verify test results.
- If normal, return to diagnostic index to service any additional symptoms.
- If malfunction remains, inspect related Service Information and perform repair or diagnosis.
• If vehicle repaired, troubleshooting completed.
• If vehicle not repaired or additional diagnostic information not available, replace PCM.