DTC U2100:00 [MZ-CD 1.6]
id0102g8328200
|
DTC U2100:00 |
Initial configuration not complete |
|---|---|
|
DETECTION CONDITION
|
• PCM cannot receive new data frames during configuration
|
|
POSSIBLE CAUSE
|
• Configuration not completed (M-MDS connection error to DLC-2)
• PCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related service repair information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
PERFORM PCM CONFIGURATION
• Perform the “PCM CONFIGURATION”.
• Clear the DTC from the PCM memory using the M-MDS.
• Start the engine.
• Perform the KOEO self test.
(See KOEO SELF TEST [MZ-CD 1.6].)
• Is the same DTC present?
|
Yes
|
Perform the “PCM CONFIGURATION” again, then go to the next step.
|
|
No
|
Go to Step 5.
(M-MDS connection error to DLC-2)
|
||
|
4
|
VERIFY THAT DTC U2100:00 TROUBLESHOOTING IS COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Run the vehicle under the FREEZE FRAME DATA stored condition.
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the after repair procedure.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [MZ-CD 1.6].)
|
|
No
|
DTC troubleshooting completed.
|
||