DTC P0380:4B [MZ-CD 1.6]
id0102g8528000
DTC P0380:4B |
Glow plug control circuit over temperature |
---|---|
DETECTION CONDITION
|
• The powerstage detects an over temperature error.
|
POSSIBLE CAUSE
|
• Glow plug control module malfunction
• Glow plug malfunction
• Connector or terminal malfunction
• PCM malfunction
|
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related service repair information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
No
|
Go to the next step.
|
||
3
|
INSPECT GLOW PLUG CONTROL MODULE CONNECTOR FOR POOR CONNECTION
• Switch the ignition to off.
• Disconnect the glow plug control module connector.
• Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace the terminal, then go to Step 8.
|
No
|
Go to the next step.
|
||
4
|
INSPECT GLOW PLUG CONTROL MODULE
• Inspect the glow plug control module.
• Is there any malfunction?
|
Yes
|
Replace the glow plug control module, then go to Step 8.
|
No
|
Go to the next step.
|
||
5
|
INSPECT GLOW PLUG CONNECTOR FOR POOR CONNECTION
• Inspect for poor connection (such as damaged/pulled-out terminals, corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace the suspected terminal, then go to Step 8.
|
No
|
Go to the next step.
|
||
6
|
INSPECT GLOW PLUG
• Inspect the glow plug and glow plug code.
• Is there any malfunction?
|
Yes
|
Replace the glow plug and/or glow plug code, then go to Step 8.
|
No
|
Go to the next step.
|
||
7
|
INSPECT PCM CONNECTOR FOR POOR CONNECTION
• Disconnect the PCM connector.
• Inspect for poor connection (such as damaged/pulled-out terminals, corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace the suspected terminal, then go to the next step.
|
No
|
Go to the next step.
|
||
8
|
VERIFY THAT DTC P0380:4B TROUBLESHOOTING IS COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Run the vehicle under the FREEZE FRAME DATA stored condition.
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM.
Go to the next step.
|
No
|
Go to the next step.
|
||
9
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the after repair procedure.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [MZ-CD 1.6].)
|
No
|
DTC troubleshooting completed.
|