 |
am2zzw00005467
WINDSHIELD WIPER MOTOR INSPECTION
id091900475000
1. Disconnect the negative battery cable.
2. Remove the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION.)
3. Remove the cowl grille. (See COWL GRILLE REMOVAL/INSTALLATION.)
4. Disconnect windshield wiper motor connector.
5. After connecting the windshield wiper motor terminal D or E to the positive battery terminal, and terminal C to the negative battery terminal, verify that the windshield wipers operate as shown in the table.
am2zzw00005467
|
|
Terminal applied to battery |
Operation condition
|
|
|---|---|---|
|
Battery negative voltage |
Battery positive voltage |
|
|
C
|
D
|
HI
|
|
E
|
LO
|
|
6. Disconnect the positive battery from terminal D or E while the wipers are operating, then verify that the wipers do not stop at the auto-stop position.
7. Connect windshield wiper motor terminals E and B, and apply battery positive voltage to terminal A.
8. Verify that the windshield wipers operate at low speed again and they are at the auto-stop position.