49 E033 101
Dust cover installer
REAR OIL SEAL REPLACEMENT [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (E))]
id0110u1800900
Special Service Tool (SST)
|
49 E033 101
Dust cover installer
|
|
Replacement Part
|
Rear oil seal
Quantity: 1
Location of use: Cylinder block
|
Oil and Chemical Type
|
Engine oil
Type: Recommended oil
|
1. Remove the transaxle. (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [F66M-R] (MTX).) (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [C66M-R (SKYACTIV-G 2.0, SKYACTIV-G 2.5)] (MTX).) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [CW6A-EL] (ATX).) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6A-EL (SKYACTIV-G 2.0, SKYACTIV-G 2.5)] (ATX).)
2. Remove the flywheel (MTX) or the drive plate (ATX). (See CLUTCH UNIT REMOVAL/INSTALLATION [F66M-R] (MTX).) (See CLUTCH UNIT REMOVAL/INSTALLATION [C66M-R, C66MX-R] (MTX).) (See DRIVE PLATE REMOVAL/INSTALLATION [CW6A-EL] (ATX).) (See DRIVE PLATE REMOVAL/INSTALLATION [ET6A-EL, ET6AX-EL] (ATX).)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
am3zzw00024910
|
|
1
|
Rear oil seal
(See Rear Oil Seal Removal Note.)
|
Rear Oil Seal Removal Note
1. Cut the rear oil seal lip using a utility knife.
2. Remove the rear oil seal using a flathead screwdriver with the tip protected by a clean cloth to prevent damage to the crankshaft.
am3zzw00024911
|
Rear Oil Seal Installation Note
1. Apply clean engine oil to the inner surface of a new rear oil seal.
2. Insert the rear oil seal into the cylinder block by hand.
3. Tap the rear oil seal in evenly using the SST and a hammer.
am3zzw00024912
|
am3zzw00028972
|
