M POSITION SWITCH INSPECTION [CW6A-EL]

id0517l1500000


Continuity Inspection

Note
•  The M position switch is built into the selector lever component.

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(E)].)

2.  Remove the following parts:

(1)  Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)
(2)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
(3)  Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)
(4)  Cup holder (See CUP HOLDER REMOVAL/INSTALLATION.)
(5)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)
(6)  Rear console (See REAR CONSOLE REMOVAL/INSTALLATION [(E)].)
(7)  Rear console bracket No.1 (See REAR CONSOLE REMOVAL/INSTALLATION [(E)].)

3.  Disconnect the selector lever component connector.

am3zzw00021700

4.  Verify that the continuity between selector lever component terminals B and H.

am3zzw00034548

•  If not as verified, replace the selector lever component. (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)

M position switch specification

Test condition

Continuity
Selector lever is in the M position.
Continuity
Selector lever is not in the M position.
No continuity