DTC P0336 [MZ-CD 1.6 (Y6) (EURO4 emission level)]
id0102g6831000
DTC P0336 |
Crankshaft position (CKP) sensor circuit range/performance problem |
---|---|
DETECTION CONDITION
|
• The PCM monitors the CKP sensor signal. If the pulse number of the CKP sensor is excessive or deficient, the PCM determines that the CKP sensor circuit has a malfunction.
|
POSSIBLE CAUSE
|
• CKP sensor malfunction
• CKP sensor is dirty.
• CKP sensor pulse wheel malfunction
• PCM malfunction
|
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related service repair information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
No
|
Go to the next step.
|
||
3
|
VERIFY RELATED PENDING CODE AND/OR DTC
• Switch the ignition to ON (engine off).
• Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure.
• Is the other PENDING CODE/DTC also present?
|
Yes
|
Go to the applicable DTC inspection.
|
No
|
Go to the next step.
|
||
4
|
INSPECT CKP SENSOR PULSE WHEEL
• Visually inspect the CKP sensor pulse wheel (crankshaft pulley).
• Is there any malfunction?
|
Yes
|
Replace the crankshaft pulley, then go to Step 6.
|
No
|
Go to the next step.
|
||
5
|
INSPECT CKP SENSOR
• Inspect the CKP sensor.
• Is there any malfunction?
|
Yes
|
Replace the CKP sensor, then go to the next step.
|
No
|
Go to the next step.
|
||
6
|
VERIFY THAT DTC P0336 TROUBLESHOOTING IS COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Run the vehicle under the FREEZE FRAME DATA stored condition.
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM.
Go to the next step.
|
No
|
Go to the next step.
|
||
7
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the after repair procedure.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
No
|
DTC troubleshooting completed.
|