NO.31 M RANGE POSITION INDICATOR LIGHT DOES NOT ILLUMINATE IN M RANGE/M RANGE POSITION INDICATOR LIGHT ILLUMINATES IN D RANGE [FN4A-EL]

id050301932000

31

M range position indicator light does not illuminate in M range/M range position indicator light illuminates in D range

DESCRIPTION

•  M range position indicator light in instrument cluster does not illuminate in M range or M range position indicator light in instrument cluster in D range with the ignition at ON.

POSSIBLE CAUSE

•  M range switch (built-in selector lever component), instrument cluster, or related wiring harness malfunction

Note

•  Before following troubleshooting steps, make sure that Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FN4A-EL].) (See BASIC INSPECTION [FN4A-EL].)

Diagnostic procedure

STEP	INSPECTION		ACTION
1	Inspect the MNL SW PID value using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [ZY, Z6].) Is the PID value normal? (See PCM INSPECTION [ZY, Z6].)	Yes	Go to Step 3.
1		No	Go to the next step.
2	Inspect the M range switch. (See M RANGE SWITCH INSPECTION [FN4A-EL].) Is the M range switch normal?	Yes	Inspect the wiring harness between PCM terminal 1N and selector lever component terminal A. Repair or replace any malfunctioning parts according to the inspection results.
2		No	Replace the selector lever component. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)
3	Retrieve the instrument cluster DTC using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER].) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER].)
3		No	Verify the M range position indicator light using the M-MDS simulation function WL+IL. (See ACTIVE COMMAND MODES INSPECTION [INSTRUMENT CLUSTER].) Replace the instrument cluster, if necessary. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
4	• Verify the test results. ― If normal, return to the diagnostic index to service any additional symptoms. ― If the malfunction remains, inspect the related Service Information and perform repair or diagnosis. • If the vehicle is repaired, troubleshooting is completed. • If the vehicle is not repaired or additional diagnostic information is not available, replace the PCM. (See PCM REMOVAL/INSTALLATION [ZY, Z6].)

31	M range position indicator light does not illuminate in M range/M range position indicator light illuminates in D range
DESCRIPTION	• M range position indicator light in instrument cluster does not illuminate in M range or M range position indicator light in instrument cluster in D range with the ignition at ON.
POSSIBLE CAUSE	• M range switch (built-in selector lever component), instrument cluster, or related wiring harness malfunction Note • Before following troubleshooting steps, make sure that Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FN4A-EL].) (See BASIC INSPECTION [FN4A-EL].)