CLUTCH PIPE AND HOSE REMOVAL/INSTALLATION [B76M-R]
id0510001570m9
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (ex: air cleaner, air hose) (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].)
3. Remove the battery component. (ex: battery, battery tray) (See BATTERY REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].)
4. Remove the clutch reserve hose while pressing the point indicated by the arrow in the figure.
L.H.D.
am3zzw00009835
|
R.H.D.
am3zzw00009836
|
5. Remove the clutch pipe and hose No.1 and No.2.
L.H.D.
am3zzw00009826
|
R.H.D.
am3zzw00009827
|
6. Verify that the seal ring is installed to the clutch pipe and hose connector.
am5ezw00005449
|
7. Install the clutch pipe and hose No.1 and No.2.
8. Insert the clutch reserve hose connector straight.
9. Pull each engagement of the clutch reserve hose and clutch pipe and hose No.1 and 2, verify that they are engaged, and then press all of them again.
10. Install in the reverse order of removal.
11. Bleed the air from the clutch system. (See CLUTCH FLUID REPLACEMENT/AIR BLEEDING [B76M-R].)