ANTENNA FEEDER NO.4 INSPECTION

id092000813200

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  A-pillar trim (RH) (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(2)  Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION.)

(3)  Rear scuff plate (RH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(4)  Tire house trim (RH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

(5)  Trunk side upper trim (5HB, RH) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

(6)  Trunk side trim (5HB, RH) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

(7)  C-pillar trim (RH) (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

3.  Disconnect the antenna feeder No.3.

am3zzw00006031

4.  Disconnect the antenna feeder No.6 or antenna amplifier connector (4SD, without RDS (radio data system)).

4SD

am3zzw00006032

5HB

am3zzw00006033

5.  Verify that the continuity between antenna feeder No.4 terminals is as indicated in the table.

am3zzw00006034

•  If not as indicated in the table, replace antenna feeder No.4.

am3zzw00006035