DTC P2109[ZJ, ZY, Z6]
id0102c1840200
With Throttle Valve Actuator Only
|
DTC P2109 |
TP sensor minimum stop range/performance problem |
|---|---|
|
DETECTION CONDITION
|
• The PCM monitors the minimum TP when the closed TP learning is completed. If the TP is less than 5° or more than 15°, the PCM determines that there is a TP sensor minimum stop range/performance problem.
Diagnostic support note
• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
• PENDING CODE is available if the PCM detects the above malfunction condition.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.
|
|
POSSIBLE CAUSE
|
• Drive-by-wire control system malfunction
• Throttle actuator malfunction
• Throttle valve malfunction
• PCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
INSPECT DRIVE-BY-WIRE CONTROL SYSTEM OPERATION
• Perform the “Drive-by-wire Control System Inspection”.
• Is there any malfunction?
|
Yes
|
Repair or replace the malfunctioning part according to the inspection results.
Then go to the Step 6.
|
|
No
|
Go to the next step.
|
||
|
4
|
INSPECT THROTTLE ACTUATOR
• Inspect the throttle actuator.
• Is there any malfunction?
|
Yes
|
Replace the throttle body, then go to Step 6.
|
|
No
|
Go to the next step.
|
||
|
5
|
INSPECT THROTTLE VALVE
• Inspect the throttle valve.
• Is there any malfunction?
|
Yes
|
Replace the throttle body, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
6
|
VERIFY TROUBLESHOOTING OF DTC P2109 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Perform the KOER self test.
• Is the PENDING CODE same as the DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
7
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE[ZJ, ZY, Z6].)
|
|
No
|
DTC troubleshooting completed.
|
||