VARIABLE TUMBLE SHUTTER VALVE SWITCH INSPECTION [ZJ, ZY, Z6]


id0140b1808200


With Throttle Valve Actuator Only

Note
•  Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See HOW TO USE THIS MANUAL.)

Voltage inspection

1.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [ZJ, ZY, Z6].)

2.  Disconnect the negative battery cable.

3.  Remove the intake manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [ZJ, ZY, Z6].)

4.  Connect the variable tumble shutter valve actuator connector.

5.  Connect the negative battery cable.

6.  Turn the ignition switch to the ON position.

7.  Verify that the variable tumble shutter valve switch output signal (M-MDS PID: IMRC) is within the specification when the variable tumble shutter valve is opened/closed by pushing with a finger. (See PCM INSPECTION [ZJ, ZY, Z6].)

•  If not within the specification, replace the intake manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [ZJ, ZY, Z6].)
•  If the monitor item condition/specification (reference) is not within the specification, even though there is no malfunction, perform the “Circuit Open/Short Inspection”.


Circuit open/short inspection

1.  Remove the PCM connector cover.

2.  Disconnect the PCM connector. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [ZJ, ZY, Z6].)

3.  Inspect the following wiring harness for open or short circuit (Continuity inspection).

am3zzw00003375

Open circuit
•  If there is no continuity, there is an open circuit. Repair or replace the wiring harness.
―  Variable tumble shutter valve actuator terminal E and PCM terminal 2AO
―  Variable tumble shutter valve actuator terminal A and PCM terminal 2AL
―  Variable tumble shutter valve actuator terminal C and PCM terminal 2J
Short circuit
•  If there is continuity, there is a short circuit. Repair or replace the wiring harness.
―  Variable tumble shutter valve actuator terminal E and body ground
―  Variable tumble shutter valve actuator terminal C and power supply
―  Variable tumble shutter valve actuator terminal A and body ground
―  Variable tumble shutter valve actuator terminal A and power supply