ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION[L3 Turbo]

id0140b6803200

Note

•  Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See HOW TO USE THIS MANUAL.)

Voltage inspection

1.  Turn the ignition switch to the ON position.

2.  Verify that the APP sensor output voltage (M-MDS PID: APP1, APP2) is within the specification. (See PCM INSPECTION[L3 Turbo].)

•  If not within the specification, replace the accelerator pedal. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION[L3 Turbo].)

•  If the monitor item condition/specification (reference) is not within the specification, even though there is no malfunction, perform the “Circuit Open/Short Inspection“.

Circuit Open/Short Inspection

am3zzw00003516

acxuuw00000119

1.  Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION[L3 Turbo].)

2.  Inspect the following wiring harnesses for an open or short circuit. (Continuity check)

Open circuit

•  If there is no continuity, there is an open circuit. Repair or replace the wiring harness.

―  APP sensor terminal A and PCM terminal 1AJ

―  APP sensor terminal B and PCM terminal 1Y

―  APP sensor terminal C and PCM terminal 1AV

―  APP sensor terminal D and PCM terminal 1U

―  APP sensor terminal E and PCM terminal 1AC

―  APP sensor terminal F and main relay terminal A

Short circuit

•  If there is continuity, there is a short circuit. Repair or replace the wiring harness.

―  APP sensor terminal A and body ground

―  APP sensor terminal B and power supply

―  APP sensor terminal C and power supply

―  APP sensor terminal C and body ground

―  APP sensor terminal D and body ground

―  APP sensor terminal E and power supply

―  APP sensor terminal F and power supply

―  APP sensor terminal F and body ground