 |
am3zzw00009366
FRONT STABILIZER REMOVAL/INSTALLATION [EXCEPT MZR-CD (RF Turbo)]
id021300800406
1. Detach the steering shaft. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Inspect the wheel alignment and adjust it if necessary. (See FRONT WHEEL ALIGNMENT.)
am3zzw00009366
|
|
1
|
Power steering pipe bracket
|
|
2
|
Pressure pipe bracket and bolt, return hose clamp (L3 Turbo)
|
|
3
|
Stabilizer control link
|
|
4
|
No.1 engine mount center bolt
|
|
5
|
Front stabilizer component
|
|
6
|
Stabilizer bracket
|
|
7
|
Stabilizer bushing
|
|
8
|
Front stabilizer
|
Front Stabilizer Component Removal Note
1. Support the front crossmember component using the jack.
2. Detach the silencer hangers on the middle pipe from the front crossmember.
am3zzw00004470
|
3. Remove the crossmember bracket.
4. Lower the front crossmember slowly approx. 90 mm {3.5 in} and remove the front stabilizer component.
Stabilizer Bracket Removal Note [Except L3 Turbo]
1. Secure the stabilizer bracket flange using a vise.
am3zzw00004471
|
2. Remove the front stabilizer.
Stabilizer Bushing Installation Note [Except L3 Turbo]
1. Verify the installation direction of the stabilizer bushing.
am3zzw00004472
|
2. Widen the stabilizer bushing opening 21—26 mm {0.9—1.0 in} and install the bushing to the front stabilizer as shown in the figure.
am3zzw00004473
|
Stabilizer Bracket Installation Note [Except L3 Turbo]
1. Install the stabilizer bracket using a vise.
am3zzw00004474
|
Front Stabilizer Component Installation Note
1. Tighten the bolts in order indicated in the figure.
am3zzw00004475
|
