TRANSAXLE RANGE (TR) SWITCH REMOVAL/INSTALLATION[FN4A-EL]

id0517a1804000

1.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION[ZJ, ZY, Z6].) (See BATTERY REMOVAL/INSTALLATION[LF, L3].)

2.  Disconnect the negative battery cable.

3.  Remove the under cover.

Caution

•  Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign material on the connector when disconnecting it.

4.  Disconnect the TR switch connector.

5.  Remove the clip and disconnect the selector cable.

am3zzw00001205

Caution

•  Do not use an impact wrench. Hold the manual shaft lever when removing the manual shaft nut, or the transaxle may be damaged.

6.  Set the adjustable wrench as shown in the figure to hold the manual shaft lever.

am3zzw00001206

7.  Remove the manual shaft nut and washer.

8.  Remove the manual shaft lever.

am3zzw00001207

9.  Remove the TR switch.

10.  Rotate the manual shaft to the converter housing side fully, then return two notches to set the N position.

am3zzw00001208

11.  Turn the protrusion between the TR switch terminals B and C until the resistance becomes 750 ohms.

am3zzw00001209

am3zzw00001210

12.  Install the TR switch while aligning the protrusion and groove as shown in the figure.

am3zzw00001211

13.  Hand-tighten the TR switch mounting bolts.

14.  Inspect the resistance between the TR switch terminals B and C.

am3zzw00001210

•  If there is any malfunction, readjust the TR switch. (See TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT[FN4A-EL].)

15.  Tighten the TR switch mounting bolts.

Caution

•  Do not use an impact wrench. Hold the manual shaft lever when removing the manual shaft nut, or the transaxle may be damaged.

16.  Install the manual shaft lever and the washer.

am3zzw00001207

17.  Set the adjustable wrench as shown in the figure to hold the manual shaft lever, and tighten the manual shaft nut.

am3zzw00001212

18.  Install the clip to the selector cable as shown in the figure.

am3zzw00001213

19.  Shift the selector lever to P position.

20.  Turn the manual shaft lever to P position.

21.  Connect the selector cable.

am3zzw00001214

22.  Inspect for continuity at the TR switch. (See TRANSAXLE RANGE (TR) SWITCH INSPECTION[FN4A-EL].)

•  If there is any malfunction, readjust the TR switch. (See TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT[FN4A-EL].)

23.  Connect the TR switch connector.

24.  Install the under cover.

25.  Connect the negative battery cable.

26.  Install the battery cover. (See BATTERY REMOVAL/INSTALLATION[ZJ, ZY, Z6].) (See BATTERY REMOVAL/INSTALLATION[LF, L3].)

27.  Inspect operation of the TR switch. (See TRANSAXLE RANGE (TR) SWITCH INSPECTION[FN4A-EL].)

•  If there is any malfunction, readjust the TR switch. (See TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT[FN4A-EL].)