KEY INTERLOCK RESISTOR INSPECTION

id051800802700

1.  Remove the battery duct and battery cover. (See BATTERY REMOVAL/INSTALLATION[LF, L3].)

2.  Disconnect the negative battery cable.

3.  Detach the bonnet release lever from the lower panel. (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION[L.H.D.].) (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION[R.H.D.].)

4.  Remove the front scuff plate. (Driver’s side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

5.  Remove the front side trim. (Driver’s side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

6.  Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION.)

7.  Remove the key interlock resistor. (See LOWER PANEL REMOVAL/INSTALLATION.)

8.  Measure resistance between the terminals of the key interlock resistor.

am3zzw00003305

•  If not as specified, replace the key interlock resistor.
Key interlock resistor resistance
6.7—7.3 ohms

9.  Install the key interlock resistor. (See LOWER PANEL REMOVAL/INSTALLATION.)

10.  Install the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION.)

11.  Install the front side trim. (Driver’s side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

12.  Install the front scuff plate. (Driver’s side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

13.  Install the bonnet release lever to the lower panel. (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION[L.H.D.].) (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION[R.H.D.].)

14.  Connect the negative battery cable.

15.  Install the battery duct and battery cover. (See BATTERY REMOVAL/INSTALLATION[LF, L3].)