DTC B2114[PJB]
id090208832300
DTC B2114 |
Front washer switch input circuit short to battery |
---|---|
DETECTION CONDITION
|
Short to power supply in wiring harness between PJB and windshield wiper and washer switch (front washer)
|
POSSIBLE CAUSE
|
• Short to power supply in wiring harness between PJB terminal J-03 B and windshield wiper and washer switch terminal A
• Windshield wiper and washer switch malfunction
• PJB malfunction
|
![]() |
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
INSPECT WINDSHIELD WIPER AND WASHER SWITCH CONNECTOR
• Turn the ignition switch off.
• Disconnect the windshield wiper and washer switch connector.
• Inspect the windshield wiper and washer switch connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace the terminal, then go to Step 5.
|
No
|
Go to the next step.
|
||
2
|
INSPECT PJB CONNECTOR
• Disconnect the PJB connector.
• Inspect the PJB connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace the terminal, then go to Step 5.
|
No
|
Go to the next step.
|
||
3
|
INSPECT WINDSHIELD WIPER AND WASHER SWITCH SIGNAL CIRCUIT FOR SHORT TO POWER SUPPLY
• Turn the ignition switch to the ON position (Engine off).
• Measure the voltage between PJB terminal J-03 B (wiring harness-side) and body GND.
• Is the voltage B+?
|
Yes
|
Repair or replace the wiring harness for a possible short to power supply, then go to Step 5.
|
No
|
Go to the next step.
|
||
4
|
INSPECT WINDSHIELD WIPER AND WASHER SWITCH
• Inspect the windshield wiper and washer switch.
• Is there any malfunction?
|
Yes
|
Replace the windshield wiper and washer switch, then go to the next step.
|
No
|
Go to the next step.
|
||
5
|
VERIFY TROUBLESHOOTING COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PJB memory using the M-MDS.
• Perform the self-test.
(See PJB SELF-TEST[PJB].)
• Is the same DTC present?
|
Yes
|
Replace the PJB.
|
No
|
DTC troubleshooting completed.
|