DTC P0615:00 [MZR 2.0 DISI i-stop]


id0102d4061500

DTC P0615:00

Starter relay circuit problem

DETECTION CONDITION
•  The PCM records DTCs when the number of times the engine has been started reaches the warrantied performance frequency for the starter or starter relay (180,000 times).
Diagnostic support note
•  This is a continuous monitor (other).
•  The MIL does not illuminate.
•  FREEZE FRAME DATA (Mode 2)/Snapshot data is not available.
•  The DTC is stored in the PCM memory.
POSSIBLE CAUSE
•  Number of times engine has been started has reached warrantied performance frequency for starter or starter relay (180,000 times).
•  PCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION

1
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
•  Verify related Service Information availability.
•  Is any related Service Information available?
Yes
Perform repair or diagnosis according to the available Service Information.
•  If the vehicle is not repaired, go to the next step.
No
Go to the next step.
2
REPLACE STARTER AND STARTER RELAY
•  Replace the starter and starter relay.
•  Reset the operational frequency of the starter and the starter relay using the M-MDS.
Go to the next step.
3
VERIFY DTC TROUBLESHOOTING COMPLETED
•  Clear the DTC from the PCM memory using the M-MDS.
•  Perform the KOEO or KOER self test.
•  Is the same DTC present?
Yes
Replace the PCM, then go to the next step.
No
Go to the next step.
4
VERIFY AFTER REPAIR PROCEDURE
•  Perform the “AFTER REPAIR PROCEDURE”.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
No
DTC troubleshooting completed.