DTC P02E1:00 [MZ-CD 1.6]
id0102g8104100
DTC P02E1:00 |
Intake shutter valve control circuit range/performance malfunction |
---|---|
DETECTION CONDITION
|
• The PCM monitors the intake shutter valve. If the following electrical error occurs, the PCM determines that there is a malfunction in the intake shutter valve.
|
POSSIBLE CAUSE
|
• Intake shutter valve malfunction
• PCM malfunction
|
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
No
|
Record FREEZE FRAME DATA on repair order, then go to the next step.
|
||
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related service information availability.
• Is any related service information available?
|
Yes
|
Perform repair or diagnosis according to available service information.
• If vehicle is not repaired, go to the next step.
|
No
|
Go to the next step.
|
||
3
|
VERIFY RELATED PENDING CODE AND/OR DTC
• Switch the ignition to ON (engine off).
• Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure.
• Is the other PENDING CODE/DTC also present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [MZ-CD 1.6].)
|
No
|
Go to the next step.
|
||
4
|
INSPECT INTAKE SHUTTER VALVE
• Inspect the intake shutter valve.
• Is there any malfunction?
|
Yes
|
Replace the intake shutter valve, then go to the next step.
|
No
|
Go to the next step.
|
||
5
|
VERIFY THAT DTC P02E1:00 TROUBLESHOOTING IS COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the memory using the M-MDS.
• Run the vehicle under the FREEZE FRAME DATA stored condition.
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM.
Go to the next step.
|
No
|
Go to the next step.
|
||
6
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the after repair procedure.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [MZ-CD 1.6].)
|
No
|
DTC troubleshooting completed.
|