DTC P0339:00 [MZ-CD 1.6]

id0102g8174800

DTC P0339:00

Crankshaft position (CKP) sensor circuit intermittent
DETECTION CONDITION
•  The PCM monitors the CKP sensor signal. The PCM determines the cycle of the teeth based on the limit according to the current engine speed. If the cycle of the teeth is inconsistent before synchronization, the PCM determines that the CKP sensor circuit signal is invalid.
POSSIBLE CAUSE
•  CKP sensor pulse wheel malfunction
•  CKP sensor malfunction
•  PCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION
1
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
•  Has the FREEZE FRAME DATA been recorded?
Yes
Go to the next step.
No
Record FREEZE FRAME DATA on repair order, then go to the next step.
2
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
•  Verify related service information availability.
•  Is any related service information available?
Yes
Perform repair or diagnosis according to available service information.
•  If vehicle is not repaired, go to the next step.
No
Go to the next step.
3
VERIFY RELATED PENDING CODE AND/OR DTC
•  Switch the ignition to ON (engine off).
•  Perform the pending trouble code access procedure and DTC reading procedure.
•  Is the other PENDING CODE/DTC also present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [MZ-CD 1.6].)
No
Go to the next step.
4
INSPECT CKP SENSOR PULSE WHEEL
•  Visually inspect the CKP sensor pulse wheel (crankshaft pulley).
•  Is there any malfunction?
Yes
Replace the crankshaft pulley, then go to Step 6.
(See TIMING BELT REMOVAL/INSTALLATION [MZ-CD 1.6].)
No
Go to the next step.
5
INSPECT CKP SENSOR
•  Inspect the CKP sensor.
•  Is there any malfunction?
Yes
Replace the CKP sensor, then go to the next step.
(See CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.6].)
No
Go to the next step.
6
VERIFY THAT DTC P0339:00 TROUBLESHOOTING IS COMPLETED
•  Make sure to reconnect all disconnected connectors.
•  Turn the ignition switch to the ON position (engine off).
•  Clear the DTC from the memory using the M-MDS.
•  Run the vehicle under the FREEZE FRAME DATA stored condition.
•  Is the same DTC present?
Yes
Repeat the inspection from Step 1.
•  If the malfunction recurs, replace the PCM.
(See PCM REMOVAL/INSTALLATION [MZ-CD 1.6].)
Go to the next step.
No
Go to the next step.
7
VERIFY AFTER REPAIR PROCEDURE
•  Perform the after repair procedure.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [MZ-CD 1.6].)
No
DTC troubleshooting completed.