ENGINE DISASSEMBLY/ASSEMBLY [MZR 1.5, MZR 1.6]
id0110s1800500
1. Using the bolts part number 99794 1025 or M10×1.25, length 25 mm {0.98 in} to install the SST to the position shown in the figure, hang the engine and transaxle, and then take it down from the engine jack.
-
Tightening torque
-
38—51 N·m {3.9—5.2 kgf·m, 29—37 ft·lbf}
2. Remove following parts:
- (1) Starter (See STARTER REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)
- (2) Joint shaft (See JOINT SHAFT REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6, MZR 2.3 DISI Turbo, MZR 2.5].)
- (3) Transaxle (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [F35M-R] (MTX).) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [FN4A-EL] (ATX).) (See CVT (CONTINUOUSLY VARIABLE TRANSAXLE) REMOVAL/INSTALLATION [DJVA-EL] (CVT).)
- (4) Exhaust manifold (See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)
- (5) Generator (See GENERATOR REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)
- (6) Fuel hose, fuel distributor and fuel injector (See FUEL INJECTOR REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)
- (7) Intake manifold (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)
- (8) Ignition coils (See IGNITION COIL REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)
- (9) CKP sensor (See CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)
- (10) Drive belt auto tensioner (See TIMING CHAIN REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)
3. Install in the reverse order of removal.
