CURRENT SENSOR INSPECTION [SKYACTIV-G 2.0]

id0140f4805300

DTC Inspection

1.  Connect the M-MDS to the DLC-2.

am3zzw00012688

2.  Perform the DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0].)

•  If any DTC related to the current sensor is present, repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [SKYACTIV-G 2.0].)

Visual Inspection

1.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

2.  Disconnect the current sensor connector.

3.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

4.  Remove the current sensor. (See CURRENT SENSOR REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

5.  Verify that there is no damage to the current sensor, and no corrosion and damage to the connector.

•  If there is a malfunction, replace the current sensor. (See CURRENT SENSOR REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)