MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR INSPECTION [MZR 2.0 DISI i-stop]

id0140j1800900

Voltage Inspection

1.  Connect the M-MDS to the DLC-2.

am3zzw00011876

2.  Switch the ignition to ON.

3.  Verify that the MAP sensor output voltage (PID: MAP) is within the specification. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.0 DISI i-stop].) (See PCM INSPECTION [MZR 2.0 DISI i-stop].)

•  If not as specified, replace the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [MZR 2.0 DISI i-stop].)