BATTERY FLUID TEMPERATURE SENSOR INSPECTION [MZR 2.0 DISI i-stop]

id0140j1889300

Voltage Inspection

1.  Connect the M-MDS to the DLC-2.

am3zzw00011899

2.  Switch the ignition to ON.

3.  Verify that the battery fluid temperature sensor output voltage (PID: BATT_TEMP) is within the specification. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.0 DISI i-stop].) (See PCM INSPECTION [MZR 2.0 DISI i-stop].)

•  If not as specified, replace the current sensor No.1/battery fluid temperature sensor. (See CURRENT SENSOR REMOVAL/INSTALLATION [MZR 2.0 DISI i-stop].)