POWER BRAKE UNIT VACUUM SENSOR INSPECTION [MZR 2.0 DISI i-stop]

id0140j1889400

Voltage Inspection

1.  Connect the M-MDS to the DLC-2.

am3zzw00011900

2.  Switch the ignition to ON.

3.  Verify that the power brake unit vacuum sensor output voltage (PID: BBP) is within the specification. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.0 DISI i-stop].) (See PCM INSPECTION [MZR 2.0 DISI i-stop].)

•  If not as specified, replace the power brake unit vacuum sensor. (See POWER BRAKE UNIT REMOVAL/INSTALLATION (L.H.D.) [MZR 1.6, MZR 2.0, MZR 2.0 DISI i-stop, MZ-CD 1.6, MZR-CD 2.2].) (See POWER BRAKE UNIT REMOVAL/INSTALLATION (R.H.D.) [MZR 2.0 DISI i-stop].)