DTC P0894:00 [FS5A-EL]

id050221820200

DTC P0894:00

Transaxle component slipping

DETECTION CONDITION

•  The TCM detects that input shaft rotation speed (PID monitor item “TSS”) is 187 rpm or more when the following conditions are met.

―  Selector lever position: D or M range

―  Accelerator pedal position: released

―  Brake pedal position: depressed

―  Vehicle speed: 0 km/h {0 mph}

Diagnostic support note

•  The MIL does not illuminate.

•  The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.

•  PENDING CODE is not available.

•  FREEZE FRAME DATA is not available.

•  The DTC is stored in the TCM memory.

POSSIBLE CAUSE

•  Shift solenoid A malfunction

•  Forward clutch not engaged or slipped

•  TCM malfunction

DTC P0894:00	Transaxle component slipping
DETECTION CONDITION	• The TCM detects that input shaft rotation speed (PID monitor item “TSS”) is 187 rpm or more when the following conditions are met. ― Selector lever position: D or M range ― Accelerator pedal position: released ― Brake pedal position: depressed ― Vehicle speed: 0 km/h {0 mph} Diagnostic support note • The MIL does not illuminate. • The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle. • PENDING CODE is not available. • FREEZE FRAME DATA is not available. • The DTC is stored in the TCM memory.
POSSIBLE CAUSE	• Shift solenoid A malfunction • Forward clutch not engaged or slipped • TCM malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY RELATED REPAIR INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. • If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	VERIFY DTCs ARE PRESENT • Switch the ignition to ON (Engine off). • Perform the “Reading DTCs Procedure”. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FS5A-EL].) • Are the following DTCs output? ― P0720:00 (VSS circuit malfunction) ― P0752:00 (Shift solenoid A stuck on) ― P0753:00 (Shift solenoid A electrical malfunction)	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FS5A-EL].)
2		No	Replace the forward clutch, then go to the next step.
3	VERIFY DTC TROUBLESHOOTING COMPLETED • Make sure to reconnect all the disconnected connectors. • Clear the DTC using the M-MDS. • Perform the following procedure to ensure that the DTC has been resolved: 1. Start the engine. 2. Release the accelerator pedal and depress the brake pedal. 3. Select the selector lever from N position to D range. • Is the same DTC present?	Yes	Replace the TCM, then go to the next step. (See TCM REMOVAL/INSTALLATION [FS5A-EL].)
3		No	Go to the next step.
4	VERIFY NO DTCs ARE PRESENT • Perform the “Reading DTCs Procedure”. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FS5A-EL].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FS5A-EL].)
4		No	DTC troubleshooting completed.